- Posts: 637
- Thank you received: 1
Please Log in or Create an account to join the conversation.
bitzo wrote: ok but with a proper negative expansion?
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
nickyburnell wrote: OK thats easy Lev, too wide though.
How much we losing if it's 636 wide?, ie 600 mouth
levyte357 wrote:
bitzo wrote: Prototyping is the definitive way to learn but a bit expensive for just an hobby.
When this cab is built H48", W24", 29"D, with approx 5" gap below rear baffle + corner bracing/deflectors, it gives stunning performance with these drivers and many similiar,
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
bitzo wrote: ok internal width 60 cm, depth from baffle 68.8 (72.5 minus 3*woodthickness). I modeled a duct to have the cornered negative expansion on the top right corner brace.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
nickyburnell wrote: Did this once.
was great
Please Log in or Create an account to join the conversation.