MHB-4818

how bad would it be to make this a little smaller? 25" tall instead of 30" - 22" deep instead of 19" -- 22" wide instead of 15.5" making the V bin 18" where the speaker is bolted in. putting 2x4 bracing all around the connections and port

---

want to be able to slide it under a table or turn it on its side and mount a speaker pole

---

thanks jim-HU

hi
how to insert speaker in this cabinet ...can u send me some pics thanks ..cheer up

what kind of wood can i use to do them ?

Will a B&C 18 TBW 100 work in this cab ???

Anybody simulated with hornresp?
The input window of Hornresp with frequency response will be better

This way we can simulate first the drivers we can use.

kentech wrote: can it be resised for a 12" woofer ?

One of the companies (fane, emenence, or someone) has some old wbin plans for a 12". Dont think its ported, but thats simple to figure out.... Check out tda audio's site, beleive its there

can it be resised for a 12" woofer ?

Can I use www.elektroeden.cz/reproduktor-e ... w+dp47036/ ??

fuck w-bins they're way outdated and suck.

diz is w-bins designs and yaah, n RCF G401 is gud spk for reverse bins.

can this cab be optimized around other speakers?

l did scketch measurement .the cab is rather too big .if lm to make 4 of them l will need a truck 2 carry them so can l make it for 15 inch speakers ? Do u have a plan for 15 inch drivers

what drivers did you use on this cab ?coz lm thinking of making 2 cabs using p.audio sd 18 and is it a long throw cab? .good work mate

Many thanks bee... smiley20

screw and glue on the tip of the v bit, u could allso fill the void in the v with foam......

Thanks bee, i am a bit worried if its not screwed, it will create some noise due to vibrations on the edges?

looking at the plan i would say yes they do touch at both points you have marked out. done a quick rework of the measurments on paper. And again the v does touch the upper and lower part of the baffle, Hope this helps.

thanks bee, how about on these portions, should be no gap between the tip of the V shape and speaker panel? please refer image below.
cheers
smiley1

the v bit sits level with the driver panal this would leave an 18mm gap to driver. 18mm being the thickness of the ply wood.

most w-bins load from the back, but look at the plans..... the driver sits on the inside of the rear chamber. You may be able to change the plan and load driver from the back.......

On second thoughts you cant change the plan as the v bit would then be wrong.....

Does the V shape touches on the panel where the speaker is mounted? Or has a small clearance? I was wondering cause it might create some noise during bass vibrations.

Very nice...

Most of these have the back removable, complete with splitter.

you would load the driver in sideways from eather side...... so the acces panel can be put on the left or right side.......

How would the Fane Colossus 18XB perform in this box?