heart MHB-4818

11 years 1 month ago - 7 years 7 months ago #9406 by giveortake
MHB-4818 was created by giveortake
Use this thread to discuss the MHB-4818 design posted here .

What is your philosophy of life or your creed ?
\"Have a good time, ALL THE TIME\"

Wisdom is better than silver and gold !

Please Log in or Create an account to join the conversation.

11 years 1 month ago #9416 by xcn
Replied by xcn on topic MHB-4818
On which side is the access panel in this case, in case the driver gets fried and has to be taken out?

Please Log in or Create an account to join the conversation.

11 years 1 month ago #9417 by xcn
Replied by xcn on topic MHB-4818
How would the Fane Colossus 18XB perform in this box?

Please Log in or Create an account to join the conversation.

11 years 1 month ago #9418 by bee
Replied by bee on topic MHB-4818
you would load the driver in sideways from eather side...... so the acces panel can be put on the left or right side.......

Please Log in or Create an account to join the conversation.

11 years 1 month ago #9419 by nickyburnell
Replied by nickyburnell on topic MHB-4818
Most of these have the back removable, complete with splitter.

Please Log in or Create an account to join the conversation.

11 years 1 month ago #9425 by xmax extreme
Replied by xmax extreme on topic MHB-4818
Very nice...
The following user(s) said Thank You: marcas58

Please Log in or Create an account to join the conversation.

11 years 1 month ago #9426 by xmax extreme
Replied by xmax extreme on topic MHB-4818
Does the V shape touches on the panel where the speaker is mounted? Or has a small clearance? I was wondering cause it might create some noise during bass vibrations.

Please Log in or Create an account to join the conversation.

11 years 1 month ago - 11 years 1 month ago #9428 by bee
Replied by bee on topic MHB-4818
most w-bins load from the back, but look at the plans..... the driver sits on the inside of the rear chamber. You may be able to change the plan and load driver from the back.......

On second thoughts you cant change the plan as the v bit would then be wrong.....

Please Log in or Create an account to join the conversation.

11 years 1 month ago #9429 by bee
Replied by bee on topic MHB-4818
the v bit sits level with the driver panal this would leave an 18mm gap to driver. 18mm being the thickness of the ply wood.

Please Log in or Create an account to join the conversation.

11 years 1 month ago #9439 by xmax extreme
Replied by xmax extreme on topic MHB-4818
thanks bee, how about on these portions, should be no gap between the tip of the V shape and speaker panel? please refer image below.
cheers
smiley1
Attachments:

Please Log in or Create an account to join the conversation.

Powered by Kunena Forum