MHB-46

hear is mykeys sim, my sim, and your sim........ all with your driver.



hope this helps......

when u press calculate, you need to go to tools, and press combined responce, then click enter, dont add a value when it ask's.......

my sim and plott is below,

re-pm...... So, i must do " Calculate" and after that , tools-combined response, but it is not active.. it;s not highlighted.. How should i do the plot ? please tell me the steps, thanx a lot !


input all the info on the main screen,
press calculate
press yes
go to tools,
select combined responce,
press ok.....

you should have the same plott as mine, is using my info posted above.....

hope this helps.......

ok i have found out why you cant sim it....... has anyone else spotted the mistake.........

kentech has got one of the parameters set to AP1......... when it should be AP.........



change ap1 to ap, it should work ok now.......

ps... if my post seem like im rambling, sorry. Im helping out via pm's.... but thought this info may help others.........

just an update,
plott 1 below is marcs sim plott using the rcf lf18n401
plott 2 below is my attempt at siming this cab using the rcf lf18n401 using akabak
plott 3 below is my attempt at siming this cab using the Selenium 18ws600 for kenwood, again using akabak,

Does anybody have the cutsheet for this design?
I calculated the amount of ply for one, and I get 2 sheets with alot of waste.
How many sheets would I need to build 4?

jerronimo wrote: Does anybody have the cutsheet for this design?
I calculated the amount of ply for one, and I get 2 sheets with alot of waste.
How many sheets would I need to build 4?

download maxcut version2 its free to use, and is one of the best cut sheet design software there is (i think)....... link below

www.maxcut.co.za/

bee, did you set the port distance from ground?

ill double check m8t, cant remember off hand.... ill take a look over the weekend

Oke I want to start building these, as my ES18BPH's are a disapointment.
Anybody got a cutsheet for the MHB-46?
How many sheets of ply would I need to build four?