Another set of mt121 on the way

The build so far, AllI have left to do is too make handles, rear access panel, and front section to housethe 2" section.

I love mt's!

i love the look of the, i love the sound of them and i love building them!

Its the only diy mid i would bother with.... shockingly loud!

I have changed the plans a bit by cutting the front to the flare and routering the bottom flare section to the base of the box. I think this gives it amoreagressive look!. To componsate for the 4mm routering on the base i have increased the hight of the rear chamber by 4mmthis keeps all the dimentions the same!.

Hopefully i should get the handles routered tomorrow and the rear access panels made will post more pics as and when i take them.

Ok i have made the rear access panels on both cabs and handles for them. The handles are not finished yet as i need to round them off.

And few more pics of the handles.

All that is left for me to do is make inside boxes for the handles round the handles off and affix the front section for the 2" horn.

Just a quick note i should of said at the start, this is my first build! and many more to come i hope.

wicked stuff man.. Lovely build, they are great boxes.. You will be amazed by the quality of the sound and stoopid spl if you have never heard them before... I know I was.

My only advice is invest in a good compression driver, you need something that will get low enough for the drop off on the mid horn ( around the 1khz mark)... A good quality 2" will do this and should get up to 16khz (unfortunatly those kinda comps ain't cheap).

I'm sure someone here could recommend you a good one.

Cheers, and thanks for the guides posted!

A.

Cheers adam, i was going to go with the recomended drivers by rog! what do you think!, any better options ive not cut the front section for the 2" yet, so i still have time to change driver choice, and not purchased drivers!.

Note to myself buy drivers!!!!