Wow the first thread.....................................
dose anybody know How to bridge a Crown xls202 there is no switch and no output bridge markings anywhere. All i know is that you have to make up a special input lead but don't know how to ? ? ? ? ? ?
use channel one for input.
output is + on speakon pin 1+, - is on speakon pin 2+. or + from the Red binding post on channel 1, and - from red binding post on channel 2.
make sure the bridge switch is engaged.
its all one the PDF on the crown website
but saying that if the amp doesnt look like it will do it, they may of canged the spec.
I think it is the same story with the crown then with the old Crest Ca's series.
All you need is a pair of jumpers on the inputPCB. With the old CA's you also could set input sensitivity on the inputPCB.