file Microphone Pre-Amplifier

11 years 7 months ago - 11 years 7 months ago #18835 by audiomik
Microphone Pre-Amplifier was created by audiomik
Hi, am looking for a single channel Microphone Pre-Amplifier, 5kOhms transformer balanced input with Phantom Power and a flat frequency response with -3dB points at 15Hz and 30kHz.
Gain needs to be ideally switchable in 10dB steps between -10 and +50dB with a level trim control, or preset, for calibration of the Microphone 'SPL' measurement to the output Voltage.
Output can be unbalanced into a 50 Ohm load with a maximum output of 7 Volts RMS before clipping.

Haven't found anything suitable from the 'usual sources' - not surprising perhaps as the application is somewhat specialised.
The purpose of the Pre-Amplifier I'm looking for is to be able to input a Measurement Microphone into either my Solartron FFT Spectrum Analyser or Bruel and Kjaer Heterodyne Analyser, for running acoustic tests.

Anyway, thought I'd ask if anyone has, or might know of, something suitable and very importantly affordable that meets the specification above before warming up my soldering iron

Thanks in advance

Mik

Please Log in or Create an account to join the conversation.

11 years 7 months ago #18857 by audiomik
Replied by audiomik on topic Re: Microphone Pre-Amplifier
Well, after much searching - found that Bruel & Kjaer manufacture something suitable but unfortunately not within my finances - so have decided to design and build something suitable myself....

Mik

Please Log in or Create an account to join the conversation.

Powered by Kunena Forum